Supermicro CSE-742I-450B Podręcznik Użytkownika

1.0aSC742 CHASSISUSER'S GUIDE742S742i

1-10SC742 Chassis User’s Guide++U6C. SCA 742 SCSI Single Channel Back Panel (w/GEM359)Front View (*Not Drawn to Scale)C-1 Connector/Jumper LocationsC-

1-11Chapter 1: Safety Information and Technical SpecificationsDrive Fail LED Indicators LED# Drive ID# SCA# D5 ID#0 SCA 1: Fail D6 ID#1 SCA 2: Fai

1-12SC742 Chassis User’s Guide(*Note: This driver is not necessary for other Operating Systems. Ifyou have two SCA backplanes, you will need to insta

1-13Chapter 1: Safety Information and Technical SpecificationsNotes

Chapter 2 Installation Instructions The special design of the SC742 chassis allows it to either be used as a tower or as a rackmount system. There a

A. Removing/Installing Drives into the 5 ¼” Drive Bays: Procedure: 1. With the side chassis cover removed, you have access to the 5 ¼” drive bays.

B. Removing/Installing Chassis Fans into the 5 ¼” Drive Bays: Procedure: 1. To remove the hot-swap chassis fans, grasp the fan handle while squeezing

II. Removing the Front Chassis Cover: You do not need to remove the front bezel to access the drives: Procedure 1. Push on the three tabs on the insi

III. Removing the Top Chassis Cover and Chassis Feet to Install as Rackmount: You will need to remove the top chassis cover to add rack rails to the c

1-2SC742 Chassis User’s GuideThe information in this User’s Guide has been carefully reviewed and is believed to beaccurate. The vendor assumes no re

1-3Chapter 1: Safety Information and Technical SpecificationsTable of ContentsChapter I: Safety Information and Technical Specifications ... 1-

1-4SC742 Chassis User’s Guide1-1 Safety InformationElectric Static Discharge (ESD) can damage electronic com-ponents. To prevent damage to your syste

1-5Chapter 1: Safety Information and Technical SpecificationsTo avoid personal injury and property damage, please carefullyfollow all the safety step

1-6SC742 Chassis User’s Guide742 SATA1-2 Technical SpecificationsA. 742 SATA Back PanelA-1 Connector/Jumper LocationsFront ViewA-2 Connec

1-7Chapter 1: Safety Information and Technical SpecificationsBuzzer Reset (JP18) Open Disabled Closed Enabled (*Default) Overheat Temperature (JP25)

1-8SC742 Chassis User’s GuideB. SCA 74-E2 SCSI Dual Channel Back Panel (W/GEM318)Front View (*Not Drawn to Scale)B-1 Connector/Jumper LocationsB-2 Co

1-9Chapter 1: Safety Information and Technical SpecificationsB-4 Connector/LED Indicator Locations (Rear)Rear View (*Not drawn to scale)D24D25D23D20D2