Supermicro AOC-XEH-IN2 Instrukcja Użytkownika Strona 237
- Strona / 392
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
7-139
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Aggregation Effect
This parameter specifies the Aggreation option as one of the following:
• Advertise – When set to advertise and associated Area ID is 0.0.0.0,
then the aggregated Type-5 are generated. Otherwise if the
associated Area ID is x.x.x.x (other than 0.0.0.0), then the aggregated
Type-7 is generated in NSSA x.x.x.x for the specified range.
• Do Not Advertise – When set to doNotAdvertise (2) and associated
Area ID is 0.0.0.0, then the Type-5 is not generated for the specified
range, while aggregated Type-7 are generated in all attached NSSA.
While if the associated Area ID is x.x.x.x (other than 0.0.0.0), then the
Type-7 are not generated in NSSA x.x.x.x for the specified range.
• Allow All – When set to allowAll and associated Area ID is 0.0.0.0,
then the aggregated Type-5 are generated for the specified range. In
addition aggregated Type-7 are generated in all attached NSSA for
the specified range.
• Deny All – When set to denyAll neither Type-5 nor Type-7 will be
generated for the specified range.
Translation This parameter enables or disables the translation.
Table 7-97. OSPF As External Aggregation Configuration Page Parameters
Parameter Description
- SuperBlade 1
- Network Modules 1
- User’s Manual 1
- REPRODUCTIVE HARM 2
- Table of Contents 3
- List of Figures 13
- List of Tables 21
- About this Manual 27
- Manual Organization 27
- Chapter 1 29
- Introduction 29
- 1-4 Contacting Supermicro 30
- Chapter 2 31
- System Safety 31
- 2-4 Operating Precautions 32
- Chapter 3 33
- Setup and Installation 33
- SBM-GEM-001 34
- Switch Modules 34
- Removing a Switch Module 35
- Network Connection 37
- SERNAME box 38
- Address Defaults 39
- Command Line 40
- Firmware 41
- Chapter 4 47
- InfiniBand Modules 47
- Chapter 4: InfiniBand Modules 49
- InfiniBand Switch LEDs 54
- Chapter 5 55
- Ethernet Modules 55
- LED Indicators 56
- Chapter 5: Ethernet Modules 57
- Pass-through Module 60
- Chapter 6 65
- 1-Gb Ethernet Switch Firmware 65
- WITCH STATUS screen in the 66
- 6-1 Port Status 68
- Port VLAN ID (PVID) 69
- Jumbo Frames Support 69
- Control Description 70
- 6-2 Statistics 71
- 6-3 VLAN 74
- 6-4 Configuring a Static VLAN 76
- 6-5 Trunking 77
- 6-6 Mirroring 79
- 6-7 Quality of Service 80
- 6-8 Rate Control 82
- 6-9 L2 Management 83
- ELETE link for that 84
- DDRESSES 84
- 6-10 Spanning Tree 85
- Port Transition State 86
- NABLE RSTP dialog 87
- PPLY GLOBAL SETTINGS button 87
- Root Status 88
- Bridge Setting 88
- RSTP Port Settings 89
- 6-11 IEEE 802.1x 90
- 802.1x Configuration 91
- 6-12 IGMP Snooping 92
- 6-13 SNMP 94
- Chapter 7 99
- 7-2 Login 100
- 7-3 Home Page 101
- Top Page Links 104
- Top LED Display 104
- Left Side Tree 104
- 7-4 System Management Page 105
- System Settings 107
- System Version 109
- File Management 110
- File Copy 111
- Firmware Upgrade 112
- Management Security 113
- Management User Account 114
- TACACS+ Global Settings 116
- TACACS+ Server Configuration 117
- IP Authorized Manager 118
- SSH Configuration 119
- SSLConfiguration 120
- ONFIGURATION page 121
- Syslog Configuration 122
- Syslog Mail Configuration 123
- MAC Based ACL 124
- IP Standard ACL 125
- IP Extended ACL 126
- Parameter Description 127
- WEBGUI Settings 128
- GENT CONTROL SETTINGS page 129
- SNMP Community Settings 130
- SNMP Group Settings 131
- SNMP Group Access Settings 132
- SNMP View Tree Settings 133
- SNMP Target Address Settings 134
- SNMP User Settings 136
- SNMP Trap Settings 137
- SNMP AgentX 138
- RMON Basic Settings 140
- Event Configuration 141
- RMON Alarm Configuration 142
- ALLING THRESHOLD 143
- QOS Basic Settings 145
- QOS Classmap Settings 146
- QOS Policymap Settings 147
- COSQ Scheduling Algorithm 148
- EIGHT value 149
- NTP Settings 150
- CX4 Cable Length 152
- Enabling Stacking 153
- Figure 7-47. Switch Diagram 154
- Stack Configuration 156
- Stack Details 157
- Stack Link Status 158
- Stack Counters 159
- 7-5 Layer 2 Management 161
- Layer 2 Basic Settings 162
- Port Manager 163
- Port Monitoring 165
- VLAN Traffic Class 166
- Port Control 167
- Rate Limiting 168
- VLAN Basic Settings 169
- Port Settings 170
- Static VLAN 171
- Protocol Group 172
- Port Protocol 172
- Vlan Port MAC Map 173
- Unicast MAC 174
- Wildcard 175
- Switch Port VLAN 176
- Dynamic Vlan 177
- Port Configuration 178
- GARP Timers 179
- RSTP Global Settings 180
- RSTP Basic Settings 181
- Port Status 183
- MSTP Basic Settings 184
- MSTP Timers 186
- VLAN Mapping 188
- CIST Port Status 190
- LA Basic Settings 192
- Interface Settings 193
- Port Channel 194
- Port State Info 196
- Load Balancing 197
- Basic Settings 198
- Local AS 202
- MAC Session Info 203
- Unicast Filters 204
- Multicast Filters 205
- 7-6 Layer 3 Management 206
- Vlan Interface 207
- IP V4 Interface Settings 208
- IP Route 209
- LoopBack Basic Settings 210
- IPv6 Route Configuration 211
- IPv6 Interface 212
- ND Cache 213
- Address Settings 214
- Address Profile 215
- Prefix Settings 216
- DHCP Server 217
- Pool Settings 218
- DHCP Relay 219
- RIP Basic Settings 221
- Interfaces 222
- Neighbors List 223
- Security Settings 224
- Address Summarization 225
- RIP6 Interface 226
- OSPF Basic Settings 229
- Interface 231
- Virtual Interface 232
- OSPF Neighbor 233
- OSPF RRD Route Configuration 234
- OSPF Area Aggregation 235
- External Aggregation 236
- OSPFv3 Basic Settings 238
- OSPF V3 External Aggregation 242
- BGP Basic Settings 244
- BGP Peer Configuration 245
- BGP MED Configuration 246
- Local Preference 247
- BGP Filter 249
- Route Aggregations 250
- Advanced BGP Configuration 251
- BGP Community Management 252
- RRD Basic Settings 254
- RRD6 Basic Settings 258
- RRD V6 OSPF 260
- VRRP Basic Settings 262
- VRRP Settings 263
- 7-7 Multicast 264
- IGMP Snooping Configuration 265
- IGMP Snooping Timer 266
- IGMP Snooping Interface 267
- IGMP Snooping VLAN Router 268
- IGMP MAC Forwarding 269
- Dynamic Multicast 270
- Interface Configuration 273
- Group Information 274
- Source Information 275
- Component 277
- Candidate RPs 279
- Threshold 280
- Static RP 281
- DVMRP Basic Settings 282
- 7-8 Statistics 284
- Ethernet Statistics 286
- ADIUS SERVER ADDRESS 288
- ORT NUMBER 288
- OUND TRIP TIME in seconds 288
- TACACS+ Statistics 290
- RMON Ethernet Statistics 292
- SNMP Statistics 294
- Current DB 297
- VLAN Port Statistics 298
- VLAN Multicast Table 299
- VLAN Counter Statistics 300
- VLAN Capabilities 301
- VLAN FDB Entries 302
- RSTP Statistics 303
- RSTP Port Statistics 304
- MSTP Statistics 306
- MSTP CIST Statistics 307
- MSTP MSTI Port Statistics 308
- Link Aggregation (LA) 309
- LA Port Statistics 310
- LA Neighbor Statistics 311
- 802.1X Session Statistics 312
- 802.1X Supplicant Statistics 313
- Mac Session Statistics 314
- ARP Cache 316
- ICMP Statistics 317
- IP V6 Interface Statistics 319
- ICMP V6 Statistics 321
- RIP Statistics 323
- RIP6 Interface Statistics 324
- RIP6 Route Information 325
- OSPF Route Information 327
- OSPF Link State DB 328
- OSPFV3 Route Information 330
- OSPFV3 Link State DB 331
- VRRP Statistics 332
- IGMP Snooping 334
- IGMP Snooping V3 Statistics 336
- IGMP Statistics 337
- PIM Interface Statistics 339
- PIM Neighbor Statistics 340
- PIM BSR Info 341
- PIM RP Set Information 342
- PIM Route Information 343
- DVMRP Routers 344
- DVMRP Multicast Routers 345
- DVMRP Prune Statistics 346
- Appendix A 369
- HCA Mezzanine Cards 369
- A-2 Mezzanine HCA Cards 370
- InfiniHost III Lx DDR chip 371
- A-3 Installation 377
- Card Installation 378
- Figure A-9. Card Installation 379
- Appendix B 381
- LED Descriptions 381
- Appendix B: LED Descriptions 383
- Descriptions 384
- Appendix C 385
- Installing Triple Wide Bays 385
- Screws 4Pcs 386
- Screws 4pcs 387
- Disclaimer 391
Powiązane produkty i podręczniki dla Karty sieciowe Supermicro AOC-XEH-IN2
(18 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji