Supermicro SuperServer 1027R-WC1R Instrukcja Użytkownika Pobierz pdf (Strona 81)

Chapter 6: Advanced Chassis Setup

6-5

Checking the Airﬂ ow

Check the Airﬂ ow

1. Make sure there are no objects obstructing the airﬂ ow in and out of the

server. In addition, if you are using a front bezel, make sure the bezel's ﬁ lter

is replaced periodically.

2. Do not operate the server without hard drives or drive carriers in the drive

bays. Use only recommended server parts.

3. Make sure no wires or foreign objects obstruct airﬂ ow through the chassis.

Pull all excess cabling out of the airﬂ ow path or use shorter cables.

4. The control panel LEDs inform you of system status. See Chapter 4 System

Interface for details on the LEDs and the control panel buttons.

6-4 Drive Bay Installation/Removal

Accessing the Drive Bays

Hard Drives: Because of their hotswap capability, you do not need to access the

inside of the chassis or power down the system to install or replace hard drives.

Proceed to the next section for instructions.

Hard Drive Installation

The hard drives are mounted in drive carriers to simplify their installation and

removal from the chassis. These carriers also help promote proper airﬂ ow for

the drive bays. For this reason, even empty carriers without drives installed must

remain in the chassis.

Installing a Hard Drive into a Drive Carrier (Figure 6-3)

1. Insert a drive into the carrier with the PCB side facing down and the connec-

tor end toward the rear of the carrier.

2. Align the drive in the carrier so that the screw holes of both line up. Note that

there are holes in the carrier marked “SATA” to aid in correct installation.

3. Secure the drive to the carrier with four screws as illustrated below.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 119 120

Brak uwag

Supermicro SuperServer 1027R-WC1R Instrukcja Użytkownika Strona 81