Supermicro SuperServer 7036A-T Instrukcja Użytkownika Pobierz pdf (Strona 36)

5-8

SUPERWORKSTATION 7036A-T User's Manual

Memory Support

The X8DAL-i supports up to 48 GB of registered ECC DDR3-1333/1066/800 or up

to 24 GB of unbuffered non-ECC DDR3-1333/1066/800 memory in 6 DIMM slots.

For best memory performance, install memory modules of the same type and speed

in the memory slots as indicated in the tables below.

DIMM Installation

Installing Memory Modules

Insert the desired number of DIMMs into the memory slots, beginning with 1.

P1DIMM #1A. (see Memory Conﬁ guration Table below).

Insert each DIMM module vertically into its slot. Pay attention to the notch 2.

along the bottom of the module to avoid installing incorrectly (see Figure 5-3).

Gently press down on the DIMM module until it snaps into place in the slot. 3.

Repeat for all modules.

CAUTION! Exercise extreme care when installing or removing DIMM

modules to prevent any possible damage.

5-6 Installing Memory

To Install: Insert module

vertically and press

down until it snaps into

place. Pay attention to

the alignment notch at

the bottom.

To Remove:

Use your thumbs to

gently push the release

tabs near both ends of

the module. This should

release it from the slot.

Figure 5-3. DIMM Installation

Top View of DDR3 Slot

Release Tab

Note: Notch should align

with the receptive key

point on the slot.

Notch

Front View

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

Brak uwag

Supermicro SuperServer 7036A-T Instrukcja Użytkownika Strona 36