Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Instrukcja Użytkownika Pobierz pdf (Strona 44)

Superblade Network Modules User’s Manual

Installing/Removing the InfiniBand Module

Before installing the InfiniBand module make sure the cover to the module has been

installed before proceeding. Refer to the anti-static precautions described in Chapter 2.

The InifiniBand module must be installed into a double-wide bay. Assuming that you

have already created a double-wide bay out of two single-wide bays, continue with the

steps below. See the SuperBlade User’s Manual for details on setting up double-wide

bays in the SuperBlade enclosure.

Installing the Module

1. Remove the dummy cover from the bay you want to place the module in.

2. Place the module's release handle in the open position.

3. Slide the module into the module bay until it stops.

4. Push the release handle to the closed position.

After the module has been installed and the handle locked, it will power on after a short

delay and a POST test will run to verify it is working properly.

Removing the Module

1. Pull out the release handle to the open position.

2. Pull the module out of the bay.

3. Replace immediately with another module or with a dummy module cover to

maintain airflow integrity.

Table 4-2. InfiniBand Module Features

Feature Description

Internal/External Ports

Internal: 10 4X DDR copper ports (capable of 14) / External: 10 4X DDR

copper ports

Bandwidth

4X DDR (20 Gbps) non-blocking architecture for 960 Gbps total bandwidth

(24-port)

Latency 160 ns port-to-port switch latency

Remote Management

In-band InfiniBand IBML (InfiniBand Maintenance Link), Command Line

Interface (CLI)

Power Consumption 34 - 40W

Operating System Firmware (upgradable)

NOTE: The 10GbE Pass-through module (SBM-XEM-002) also requires the

same double-wide bay as the InfiniBand module and may be installed instead of

the InfiniBand module in your blade enclosure system. Use the same

instructions below for installing either the pass-through module or the InfiniBand

module.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 333 334

Brak uwag

Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Instrukcja Użytkownika Strona 44